model layout

Post here for very basic questions and request for help...
But: BEFORE you post, read the older posts if your question hasn't been answered before.
Please be specific. Q like "I don't understand ENVI-met" will most likely be ignored.
Post Reply
LyMier
Posts: 6
Joined: Fri Aug 14, 2020 2:36 pm

model layout

Post by LyMier »

Hello, I would like to ask: in the model layout in the figure, how to determine the distance from the model to the boundary?What is the basis?I know I have the "Model Inspector" tool in the Space module. What is the basis for this tool?Can I not depend on it?If so, by what should I set the boundary distance?

Best wish!
Attachments
KO}PRU}7ZSA`05R[1D1~DLJ.png

helge
Posts: 142
Joined: Mon May 15, 2017 12:27 pm

Re: model layout

Post by helge »

Dear LyMier,

there is no strict value for it. For stability it is advised to have around half the distance of the nearest building height as open space.

Best
Helge

LyMier
Posts: 6
Joined: Fri Aug 14, 2020 2:36 pm

Re: model layout

Post by LyMier »

Thank you for your answer

Post Reply