Constant meteorological parameters

Post here for very basic questions and request for help...
But: BEFORE you post, read the older posts if your question hasn't been answered before.
Please be specific. Q like "I don't understand ENVI-met" will most likely be ignored.
Post Reply
kac116
Posts: 12
Joined: Mon Aug 05, 2019 10:22 am

Constant meteorological parameters

Post by kac116 »

Hi everyone,
I hope you're doing well.
I need to validate my model against a wind tunnel experiment. To do this, I need to establish constant meteorological parameters. I already set the same Max and Min values for temperature and humidity, but still, I have variation in my model over the day.
How can I set constants meteorological parameters? Or set constant boundary conditions?
Thanks
All the best

Tim
Posts: 1873
Joined: Mon May 15, 2017 3:46 pm

Re: Constant meteorological parameters

Post by Tim »

Hi,

I would recommend you to use the SimpleForcing mode and set the temperature and humidity values to constant values in the table on the right hand side. Wind and wind direction are also constant in SimpleForcing.

Best regards,
Tim

Post Reply